1, get on the bus, close the door, fasten the seat belt, adjust the seat and adjust the mirror.
2. Turn on the left turn signal, honk the horn, step on the clutch brake, shift to 1, release the brake, lightly lift the clutch, release the brake, and start smoothly.
3. Half-slope start: aim the wiper root at the yellow line on the right, and fine-tune the distance so that the car body is 20 to 25 cm away from the yellow line. Look at the mirror on the left, make the window grilles on the left aim at the first oncoming white line and stop at the right. When the clutch is released to the semi-linkage state, release the brake and continue to release the clutch to make the car pass the ramp.
4. Right-angle turn: When entering the right-angle turn test area, turn the corner wider, leave enough space to adjust the direction, and keep the right line at one third of the front of the car. When the protruding point of the car driving at right angle is at half of the window triangle, kill the car to the left until the car body returns to the right.
5. Returning to the depot: When entering the site, aim the steering wheel at the right line of parking ahead, and stop after the yellow line crosses rubber strip to ensure that the front wheel is pressed. Keep the car body about one meter to one and a half meters away from the left line. When reversing, when the lower edge of the left rearview mirror is about 2 cm away from the sideline, the steering wheel is killed to the right. When the car enters the garage, return to the right direction and stop at a fixed point.
6. Side parking: First, control the car body to be about 30cm away from the dotted line on the right, and stop after the front of the car covers the left line of curve driving. Turn on the right turn signal, honk the horn and step back until the lower edge of the right rearview mirror covers the horizontal line. In three seconds, the direction will kill to the right. Look at the mirror on the left.
When the transverse right rear corner appears, turn around and look back at the direction when the sash of the left rear window coincides with the horizontal line. When the car completely enters the side bearing, return to the positive direction and stop in time. Turn left, honk, and then turn left. Drive until the left car body is 30 cm away from the lateral line, and continue to drive until the middle of the front of the car intersects with the lateral line.
7. Driving in a curve: When the rubber strip of the right window is aligned with the right line of the curve, it will enter the curve in the right direction, then it will be straightened when the right line coincides with one third of the front of the car, then it will turn around when the left front corner of the car coincides with the right line, and then the left front corner will coincide with the right line.
When entering the right corner, the left front corner will return to the positive direction when it coincides with the left line, and will return once when the right front corner coincides with the left line. Then the right front corner will coincide with the left line of driving, and the distance will be adjusted appropriately so that the wheel will not press any sideline. When you want to drive out of the corner, just return to the positive direction.