There are several ways to sew tiles beautifully.

With the improvement of people's living standards and the change of aesthetic concepts, the requirements for family decoration are getting higher and higher. According to our previous ordinary decoration method, there will still be cracks in the tiles laid at home, which is not good-looking. Now, a new tile joint technology has been developed, which can optimize this problem. Tile joints can beautify the paved tiles with very good effect, which can make the decorated tiles more tidy, durable and beautiful. But the construction technology is very strict, so many people don't quite understand it. What Bian Xiao wants to share with you today is the method of tile joint and the matters needing attention in tile joint. If you are interested, you can continue to look at the following.

Beautiful joint method of ceramic tile

1, tool preparation: glue gun, wallpaper knife, silicone scraper, bucket, textured paper;

2. Choose the color of the ceramic tile sealant: the general customers will determine it according to their own preferences;

3. Operating steps: poke a hole in the bottle mouth of the ceramic tile sealant, then screw on the discharge nozzle, then cut the discharge nozzle into a 45-degree angle with wallpaper knife, and the joint of the ceramic tile is less than 2mm, and then cut the front end of the discharge nozzle into an oblique angle with wallpaper knife; Ceramic tile joint is greater than 2 mm, which can be slightly cut off; The width of the discharge nozzle should be smaller than the joint width to ensure that it will not overflow;

4, the construction method:

(1) Clean up the site after entering the site, and then use wallpaper knife to clean up the filler in the joint and on both sides of the ceramic tile, so that there is no floating dust on the ground;

(2) Dip the sponge in water and quickly wipe the joint of ceramic tile. After confirming that there is no dust, evenly hit the material at the joint of the ceramic tile with a glue gun, and brush it about 1 m to block the discharge nozzle;

(3) Scrape the material with silicone rubber plate immediately, and a small amount of material overflows on both sides of the brick joint. Wipe it with a slightly wet sponge, and wipe it several times. The sponge should be washed with water frequently;

(4) Wait for an area to finish before starting from scratch to ensure the construction quality;

5. Construction quality standard: The brick surface is required to be smooth and free from edges and corners, bubbles, pits and flash. Before leaving the construction site, the ground is as clean as new;

6. If the customer is afraid that the overflow on the brick surface can't be cleaned, he can stick it on the edge of the brick seam with masking paper, and then use a glue gun to strike the material. After leveling with a scraper, when the material is dry and repaired, you can open the textured paper.

Matters needing attention in tile sewing

1, to ensure that the joint bottom of building tiles must be flat, firm, dust-free and moisture-proof;

2. The width of the discharge nozzle is slightly smaller than the width of the joint, so it is advisable that the discharge can completely cover the bottom surface of the joint of the ceramic tile;

3, discharging should be uniform, should be less should not be more, in case of cross interface more small brick should be gently leveling;

4, the construction temperature 15-30 degrees, be sure to clean up the spill while construction;

5, the ground construction within 3 hours, don't walk on it, so as to avoid dirt pollution sealant surface.

abstract

The technical requirements of tile joint construction are quite strict. You should be careful, patient and choose good materials. Otherwise, the effect of decoration will be the same as that without joints, so it is best to choose some familiar old employees or ask the decoration company for help. In terms of materials, it is necessary to choose reliable brands, and tiles are widely used at home. Since the house has been renovated, don't omit this step. Doing tile joints can also prevent tile leakage, easy cleaning and many other advantages. If you want to know more, you can continue to pay attention to our Tuba Rabbit Decoration Network.