Generally speaking, there are three places where Hublot quartz watches are easy to get water: the handle, the cover and the back cover. Therefore, the general waterproof device of Hublot quartz watch is also installed in these places where water is easy to enter. Rubber rings are added to the handle head, and rubber rings are added to the threaded side of the back cover for sealing rings, handle tubes and other parts, and the surface is tightly covered. With these facilities, watches can be waterproof. But can Hublot be waterproof all the time? The answer is no, according to the ideal design scheme, Hublot quartz watch is absolutely waterproof. However, since quartz watches should be wound every day and the needles should be fixed frequently, the waterproof ring will wear out and there will be gaps over time, and the sweat on our hands and necks will also corrode the waterproof apron on the back cover. Even without sweat corrosion, the apron itself will become loose over time.
As for the surface coating and surface gloss, they are not the same material, and the coefficients of cold shrinkage and thermal expansion are different, so there will be tiny cracks after a long time. All these may seep into the watch movement, but there is little water. Many watch wearers have no knowledge of watch maintenance. Here, Bian Xiao explains four most commonly used methods to treat the water ingress of Hublot quartz watches for the majority of watch lovers, which can help more watch wearers to remove the water vapor from their watches correctly and efficiently, thus increasing the service life of watches.
The following are the four most commonly used methods: First, when the quartz watch is flooded, you can directly wrap a small piece of calcium chloride or silica gel with gauze; Then take out the watch cover and seal the gauze-wrapped calcium chloride and electronic watch in plastic bags and boxes. After waiting for a long time, you can take out your watch and see that the water vapor in the electronic watch has disappeared. If the watch is seriously flooded, you can leave it for one day. Second, if there is too much water in the watch, it should be sent to the watch repair shop for repair. Third, the surface of the watch can be reflected inward, while the bottom shell of the watch is outward. Wearing a watch on your wrist for about two hours can also eliminate hand steam. Fourthly, if water drops adhere to the watch cover for a long time, it is easy to cause parts to rust and affect the accuracy of walking. In this case, you can wrap the watch tightly with several layers of toilet paper or absorbent flannel and bake it near the 40-watt bulb for about half an hour. The water in the watch will turn into steam and be discharged.