1. How long can it last after sewing?
If it is 12 hours after the completion of two-component joint agent, the floor can be cleaned, but if the temperature in winter is below zero, the cleaning time of joint slag will be longer, which may take 48 hours. One-component sewing agent is soft and its curing time is slow, which is estimated to take about one or two weeks. When the brick is dry, mop the floor, otherwise it will be easy to powder and lead to discoloration.
Second, how to clean the joints?
1, clean up the obvious decoration garbage on the ground first, and the cleaning direction is best from top to bottom. Then clean up the dust on the ground with a broom. If there is a vacuum cleaner, the effect will be better, saving us a lot of time.
2. Wet the mop slightly to clean the tile surface. Remember: it can only be slightly wet. If you mop the floor directly with a dripping mop, water stains will enter the gap, causing the gap to be wet. Before joint construction, the surface of ceramic tile should be kept dry. If the gap of the tile is still wet or there is water, it is best to wait until it is dry before proceeding to the next construction process, otherwise the cement will not solidify.
3. If there are still caulking agents or cement impurities in the gaps of ceramic tiles, it is necessary to clean the gaps with joint cleaning tools first, and then clean them with brushes or vacuum cleaners. You can't leave them at the bottom of the crack to clean a certain depth and width. If it is cement, it needs to be cleaned with professional joint cleaning tools.
4. If the water-based sewing agent drops on the tile, wipe it off with a wet towel immediately; If the surface of the tile is smooth, wait for the sealant to dry before shoveling it off; If the tiles are rough, it is best to wipe them with alcohol or buy a glue remover.
Conclusion of the article: The relevant knowledge about the sewing agent is introduced here for everyone, hoping to help everyone.