First, the process
1. Installing sealing strip
In order to prevent mildew, the sealing strip should be installed before adding aluminum strip on the edge of the bathroom screen, which plays the role of sealing, mildew prevention and mute.
2. Connecting frame
After the sealing strip is installed, the glass is embedded in the aluminum strip, which can protect the glass. The aluminum strip needs to be used as a frame and then fixed to the wall through the frame connection.
3. Fix with screws
After aluminum bars are fastened, aluminum bars and glass, aluminum bars and aluminum bars should be fixed with screws to form a frame.
In this process, it is very important to install screws and fix them.
The screws need to be tightened to ensure that the connected frames will not fall apart.
4. Place the frame in the installation position.
After mounting, move to the bathroom.
Move the glass as a sliding door to the bathroom alone, and the bottom can be protected by foam.
Then put the shelf on the water retaining stone.
When placing, it should be carefully debugged to avoid scratching the wall tiles twice.
Second, the installation is fixed.
1, calibrate the drilling position.
In order to ensure the installation level of partition wall, tape measure and pen should be used to determine the installation position.
Taking the edge line of the tile as a reference, measure the distance from the edge line to the edge line of the frame, fix a value, and then mark the drilling position on the tile with a colored pen.
2. Drill holes at the marked positions
Use an impact drill to drill installation holes in turn at the marked positions.
Before drilling, make sure that there are no water pipes and circuits at the drilling location.
3. Install colloidal particles
When drilling holes in the wall, colloidal particles must be installed in the holes.
Rubber particles can tighten screws better.
Knock the colloidal particles into the hole with a hammer.
4. Install the screws for fixing.
After installing rubber particles in the mounting holes, align the frame holes with the mounting holes and install the screws with a screwdriver.
Third, install the sliding door and glue it.
After installing the frame with a piece of glass, you can install another piece of glass.
The remaining glass can be used as a sliding door of the screen and can be moved.
1. Install sliding door wheel.
The sliding door needs to be moved by means of pulleys, and glass sliding door has reserved holes for installing wheels, so it is necessary to install two wheels above the upper sliding door, put them in the corresponding positions after installation, and then debug and install the lower wheels.
Step 2 Repair the sliding door
Generally, glass sliding door is fixed with the upper wheel first, and then with the lower wheel.
3. Install the sealing strip
After the sliding door is installed, the exposed glass frame needs to be sealed and silenced by sealing strips.
4. Install the sliding door handle
The installation of the handle is relatively simple, and the handle and the screw can be fixed in a fixed position with a screwdriver.
5. Debugging the sliding door
After the sliding door is installed, the debugging link is also essential. Try pushing the sliding door to check whether the opening and closing are smooth and seamless.
If there is a gap, measures should be taken to debug it.
6. Glue sealing is completed
Glue the frame and the wall with transparent glass glue, which can be waterproof and mildew-proof.
National Owner Decoration Exchange Group 573032 185