Therefore, the most basic requirements for the installation position of the indoor unit are: the left and right sides should not be less than 12cm, the upper side should not be less than 15cm, and the lower side should not be less than 200cm (using split wall hanging machine).
When designing the installation position of air conditioner indoors, the first thing to consider is to take full care of the indoor cold and hot air circulation. The cold air from the air conditioner is heavy and deposited at the bottom of the room, while the lighter hot air floats above the room. In order for the air conditioner to smoothly "suck" these "hot" air into the heat exchanger of the air conditioner, the air conditioner must be installed at the height of the room.
Install air conditioning in the room to avoid cold air blowing people, and at the same time, hot air needs to blow people directly when heating. It's a bit contradictory, but it's actually not difficult to do it, because in the design of air conditioning, in the cooling state, the air outlet is designed to blow horizontally and directly, and in the heating state, because the hot air is "light", in order to get better air circulation as much as possible.
If the bedroom is equipped with air conditioning, the most suitable position is directly above the bedside; The best place to install air conditioning in the living room or sitting room is directly above the person. For example, if the sofa is placed against the wall, then the air conditioner is installed on this wall, right above the sofa.
Extended data:
Precautions for installation:
1, the position of evaporator must use thermal insulation foam glue.
2. The remote control needs to be coded (see the first page of the manual for details).
3, check valve shall not be installed backwards.
4. When installing copper tube, be sure to use two wrenches.
5. After the copper pipe is connected, it must be glued with foam, and there can be no exposed place at the joint.
6. The air conditioner leans slightly outward. Many air conditioners hang up because of improper installation. After a period of use, the indoor unit often drips water, even if it is unplugged, it will not help. At this time, the air conditioning hole should be slightly adjusted, which can not only prevent the snow water from going out along the air conditioning hole in rainy days, but also prevent the incident that the dripping radiator tube is "high outside and low inside" and causes the air conditioning water to flow backwards again.
7. The socket of the air conditioner should be as close as possible to the wall of the air conditioner hole, and the position of the socket should also be particular. Should be as close as possible to the air conditioning hole wall. This is mainly for the sake of beauty, so pay attention to the arrangement of dark lines in the bedroom. Otherwise, if the distance between air conditioner, air conditioner hole and air conditioner power socket is large, there must be two obvious open wires, air conditioner tube and power cord, which will affect the appearance.
References:
Baidu encyclopedia-air conditioning