Difference between Begonia Angle and 45-degree Angle
1, Haitangjiao
Cut the ceramic tile to 45 degrees, but don't cut it to the bottom, leaving 2mm at the bottom (increase the closed surface and reduce porcelain collapse through beautiful joint). Begonia horn is a test of the master's skill (to be cut flat and reserved uniformly). If the master is not sure that the tile factory can process it, it is recommended to find a better master to rest assured. Advantages and disadvantages are beautiful and generous, but in some places, money needs to be increased because of labor (personally, I feel that there is not much more, so I will live for a lifetime).
2.45 degree angle
Tile edges are spliced at a 45-degree angle, which is acceptable in appearance, but the corners are sharp, easy to collapse and difficult to repair. It takes time, money and money to cut bricks, just like Begonia Cape. Personally, it is not recommended.
Which labor cost is higher, Begonia Angle or 45-degree Angle?
Gaohaitangjiao
Literally, I will simply say: for many sales people, he doesn't know what begonia is. In fact, the angle of begonia also belongs to 45 degrees, but the chamfering method is different. Both ceramic tiles and porcelain tiles can be touched on the spot. It's just a question of whether they are willing to do it or not. If the workers don't want to chamfer on site, let the tile dealer pull it to the processing factory for chamfering. There is a saying that chamfering should not be directly glazed, but should be 2% off the glaze. Leave a gap of two millimeters between two bricks, which is a normal touch angle, no matter it is a 45-degree touch angle, so some people call it Haitang Angle. If you pour it directly into the glaze without leaving a seam, sooner or later the porcelain will pop up at the corner. This is Liang Zi's explanation of touch angle.
The external angle line is divided into PVC external angle line and aluminum-American alloy external angle line, as well as process external angle line and resin external angle line. The most common external corner line is the PVC external corner line presented by the merchants. Some PVC outer corner lines will oxidize and yellow for a long time, but the cost is relatively cheap. At present, the process corner line and resin corner line are widely used in the market, which are slightly higher than PVC corner line, but convenient for workers to construct.
Jiaomei sewing effect of begonia.
Grind the edge of the tile to a 45-degree angle, but not to the end, and keep a certain side, about 2-3mm, which can increase the area of the side opening and reduce the possibility of porcelain pulling. The change of side leakage can be covered up with beautiful seams in the later stage. Also known as Haitangjiao.