1, don't look down at the dashboard and gear when driving. Some new drivers will feel the dashboard at the beginning of driving, which is actually very dangerous. As long as you get on the bus, you must adjust your seat and adjust the rearview mirror to the right position. When you start, you should look around and stare at the dashboard, so you won't have time to observe the surrounding environment.
2. Start in first gear. Push the clutch to the bottom, put it in first gear and release the brake. First, lightly step on the accelerator with your right foot and keep it steady, and then slowly release the clutch. When you feel the car moving (the joint of the clutch), hold the clutch firmly (that is, stop completely). After the car runs smoothly, slowly and completely release the clutch and slowly step on the accelerator, and the car can start smoothly.
3. Step on the clutch to the end. The role of the clutch is to be able to "completely separate" and "reliably engage". When the clutch is in a semi-disengaged or semi-engaged state, it is called "semi-linkage".
4. Don't jump gears. Skipping may lead to mismatch between the vehicle speed and the engine speed, and the vehicle may shake or the engine speed is too fast to produce loud noise; And skipping gears consumes more fuel than stepping gears.
5. accelerate. The upshift is definitely for acceleration, but the operation of acceleration is not just upshift. Take the five-speed gearbox as an example: if it is currently in the fourth gear, it is necessary to accelerate the overtaking of the front car, directly increase the throttle without shifting gears, and then change to the fifth gear after overtaking the front car; If it is currently in the fifth gear, you need to speed up overtaking the front car, you can shift to the fourth gear, increase the throttle, and then change back to the fifth gear after overtaking the front car.
Extended data:
The precautions for manual gear are as follows:
1, the shift is not completely separated. Usually when learning to drive, some impatient students are busy shifting gears without stepping on the clutch to the end, which is not only difficult to shift gears accurately, but also will cause fatal damage to the gearbox of manual transmission in the long run.
2. Long-term semi-clutch state. Some drivers are used to stepping on the clutch with their left foot all the time while driving, thinking that this can better keep control of the vehicle, but in fact this practice is extremely harmful to the clutch plate. Especially when the vehicle is driving on the expressway, the long-term semi-clutch state will make the clutch plate wear quickly.
3. Always operate the combination switch. The flashing lights will make the driver feel good about himself, but frequent switches increase the probability of damage to the combination switch. Because when the switch is turned on, the current passing through the switch contact will be much higher than usual, and when it is ignited in the state of half-closing and half-opening, the spark will easily burn the contact.
References:
Phoenix Net-How to open the manual gear?