2. When bonding articles, it is necessary to mix the two adhesives evenly according to the ratio of one to one, and then apply them to the articles to be bonded.
3, if you don't use the two kinds of glue together, you can also coat the two kinds of glue on both ends of the glue respectively, and you can also achieve the effect of fusion.
4. The bonded articles must be free of burrs and dirt, and the two bonding interfaces should be kept flat to achieve a firm bonding effect.
5. When the adhesive is applied to the adhesive, the adhesive will not be reinforced immediately after bonding. The adhered articles should be fixed and cannot be separated. Wait until the adhesive is strengthened, and then remove the fixture. Please refer to the instruction manual for specific strength time.
Matters needing attention when using Gelihao universal adhesive:
The optimum bonding temperature of 1. all-purpose adhesive is 25℃ 5℃ and the humidity is 55%-75%. Be sure to mix well before use.
2. All-purpose adhesive should be stored in a cool and ventilated place, where the temperature is too high, the sealing performance is not good, the exposure time is too long, or the solvent is too volatile to be constructed. Please dilute it with toluene, ethyl acetate, xylenol or acetone first, and then use it after stirring.
3. When the temperature of the all-purpose adhesive is lower than-15℃ in winter, it may gel and affect its use. But after heating to 15℃-30℃, it can be restored to its original state and its performance remains unchanged. The heating method can be soaked in hot water at 30℃-50℃.