It is stipulated in the driving test that the ignition must be started in neutral, otherwise the score will be deducted directly 100. It can be seen that neutral ignition is the premise of manual ignition. Beginners, in particular, must gradually develop this good habit.
If the ignition is in the gear position and the clutch is not stepped on, Xiangqian Che will rush for a certain distance, which will easily lead to rear-end collision. At the same time, the engine flameout will occur under heavy load, which will cause abnormal wear and tear to the engine.
Therefore, before ignition, the gear must be in the neutral position.
Note: When in neutral, don't swing the shift lever back and forth in neutral, which will accelerate the wear of the shift fork and make it difficult to shift gears over time.
Secondly, don't screw the ignition switch to the end.
As shown in the figure below, the automobile ignition switch has four gears, namely LOCK, ACC, on and START.
The lock is a steering wheel lock;
Accessory circuit switch. Turn to this gear, the vehicle circuit is connected, and the vehicle circuit system starts self-inspection.
ON is the normal operating position of the engine. After ignition, the key will automatically return to this position.
Starting is the engine ignition device. Twist this gear, start the motor to work, drive the engine flywheel to rotate, and drive the ignition.
When igniting, first turn the key to ACC position and stay for about 3-5 seconds, so that the automobile circuit can complete the self-test. After normal, turn and start ignition. This helps to protect the engine.
Note that once the engine is successfully ignited, the key should be released in time and returned to the ON position. Otherwise, the gear of the starting motor will not be separated from the flywheel of the engine, which may damage the starting motor due to the high speed of the flywheel.
After the ignition is successful, you can step on the clutch and shift to 1 to complete the subsequent normal start.