How to construct Nippon wall paint?

1. Construction technology of latex paint: \x0d\ process flow: cleaning the base surface-filling gaps, locally scraping putty-screeding-first full scraping putty (generally horizontal scraping)-screeding-second full scraping putty (vertical scraping perpendicular to the first direction)-screeding-drying oil priming-first coating-re-scraping putty-screeding (polishing). 2. Common construction quality problems: \x0d\ 1, powdering \ 2, frosting \ 3, brush marks or unevenness \x0d\ 4, pilling \ 5, sagging \ 6, whitening and fading \x0d\ 3, and preventive measures \ x0d \/kloc. \x0d\ 2。 Before use, fully mix the coating evenly. (When a package is not used up, the required amount should be poured out of other containers, and then diluted with water, not directly diluted with water in the paint packaging barrel). \x0d\ 3。 Select matching putty and corresponding primer with better performance to treat the surface of wall base. \x0d\ 4。 The interval between repainting must be long enough to ensure that the bottom layer is dry. \x0d\ 5。 Adjust the construction viscosity of the coating to a suitable range (dilute it appropriately according to the product instructions), and control the coating thickness, which should not be too thin or too thick. Ensure the number of times of painting (generally two or three times) \x0d\ 6. The same batch of paint should be applied to independent surfaces at one time and completed at one time. If it is mixed with other paints, the manufacturer should be consulted in advance. \x0d\ 7。 Strengthen the ventilation of the construction site, dip less and frequently, and clean and replace tools in time. And it is not suitable for construction in low temperature or high temperature places. \x0d\ 8。 It takes about seven days for the coating to completely dry to achieve the best effect. \x0d\ 9。 When spraying, use a spray gun with a diameter of 2-6mm, the air displacement of the air compressor is 0.6m3/min, the pressure during spraying should be kept at about 0.4-0.7Mpa according to the consistency of the coating, and the air inlet valve of the spray gun should be adjusted to spray into mist. The distance between the spray gun and the wall should be controlled at 350-600mm, the distance between the nozzle and the wall should be consistent, and the running line should be parallel to the wall. \x0d\ 10。 Spraying should be carried out side by side, and the coating seams must be left in the frame to prevent "false spraying" and "face painting". When the color of the joint is uneven, first use sandpaper to polish off the thicker part, and then spray it all over the frame joints, and the thickness of each spray can cover the bottom. Not too thick, and not too hard to spray.