Maintenance procedure of grinding machine
First, there should be no other sundries around the equipment, and the surface of the equipment should be kept clean. Second, production operators should carry out production operations in strict accordance with standard operating procedures, and it is strictly forbidden to operate at will.
Third, the equipment circuit must be reliably grounded to protect personal safety.
Four, grinding wheel must go through strict inspection before installation and use, grinding wheel with defects such as cracks is absolutely not allowed to install and use.
Five, check whether the characteristics of the grinding wheel meet the use requirements, whether the grinding wheel and spindle size match.
Six, freely assemble the grinding wheel to the grinding wheel spindle, don't squeeze it hard, and the fit clearance between the inner diameter of the grinding wheel and the spindle and chuck should be appropriate to avoid being too big or too small.
Seven, tighten the tightness of the grinding wheel to drive the grinding wheel not to slide, not too tight.
Eight, after adjusting the balance, the grinding wheel should be put on the protective cover for idling test, and the idling test time should be no less than 2 minutes. 9. Is there any abnormal noise in the operation of the equipment? X. Is the equipment damaged or missing parts? Eleven, take care of the machine, it is forbidden to barbaric operation. Twelve, it is forbidden to use steel tools to beat the grinding wheel. Thirteen, if there is any abnormality in the operation of the equipment, stop reporting in time.