If the goods are in the catalogue stipulated in the green channel policy, they shall be free of charge and shall meet the following requirements:
1, complete operation procedures.
2, fresh agricultural products loading capacity of not less than 80% of the rated load, shall not be overloaded.
You must take the special exit of the green passage.
4. Scope of fresh agricultural products: On the basis of the original catalogue of fresh agricultural products, potatoes, sweet potatoes (sweet potatoes, yams, taro), fresh corn and flowers are added.
5. Definition and legal loading standard of vehicles:
(1) The definition standard of a complete vehicle is that the weight or volume of the vehicle loaded with fresh agricultural products reaches more than 80% of the nuclear load mass or trunk volume of the vehicle.
(2) The definition standard of legal loading is that the vehicle loading shall not exceed the vehicle loading quota standard jointly stipulated by seven ministries, that is, the total weight of two-axle trucks shall not exceed 20 tons (including 20 tons), three-axle trucks shall not exceed 30 tons (including 30 tons), four-axle trucks shall not exceed 40 tons (including 40 tons) and five-axle trucks shall not exceed 50 tons (including 50 tons). At the same time, considering the possible reasonable error of weighing equipment, vehicles transporting fresh agricultural products below 5% overrun shall be carried out according to legally loaded vehicles.
Law enforcement detaining vehicles is not allowed to charge so-called parking fees at all. It is a normal law enforcement behavior for the traffic police to temporarily detain the vehicle. The expenses incurred by detaining the vehicle belong to the normal law enforcement expenditure of the traffic police team, and the owner has no obligation to pay for the entrusted behavior of the traffic police. After the traffic police handle the violation, they should give the car to the owner intact. The law does not stipulate that car owners must pay, so there is no basis for car owners to pay parking fees.
1, the first four and the last eight, 9 meters and six carts pull vegetables, with a weight limit of 20-40 tons.
2. The so-called first four and then eight means four wheels in front and eight wheels in the back. The first four means that there are four wheels in front, and the last eight are also double bridges, that is, eight-wheel drive, with four wheels on each bridge and two wheels on the left and right sides of each bridge. Generally speaking, a double-bridge single-bridge means that there are several drive axles behind it. Common "front four and rear eight" vehicles include various dump trucks, heavy trucks and trailers.
The minimum weight limit of the nine-meter-six truck pull green pass needs to be determined according to each province, and each province is different. It should be noted that the goods pulled by the truck need to be filled with three-quarters of the car to take the green channel; When passing through the expressway toll station, you need all kinds of documents and certificates; According to the load standard stipulated by the vehicle, overweight is not allowed. The minimum length of the 9.6-meter three-axis green pass is 9.6 meters, and the minimum length of the first four and the last eight green passes should be 40 tons, and the toll can be paid free of charge. Three axes are three axes, and so on. Many transmission shafts are used to transmit driving force from the engine to the driving wheels. The axle here is simply that only the connecting bridge between the two wheels is called an axle, that is, an axle.
Three-axis introduction
Whether it is a vehicle or a semi-trailer, a vehicle with only one front axle and one rear axle is called a two-axle vehicle, a vehicle with only one front axle and two rear axles is called a three-axle vehicle, a vehicle with only two front axles and two rear axles is called a four-axle vehicle, and several axles are just a few axles. Machining center, with the continuous progress of industrial manufacturing technology and numerical control technology, multi-axis linkage technologies such as three-axis, four-axis and five-axis are becoming more and more mature.
Machining centers are more and more widely used in various fields of machinery manufacturing, and many manufacturers also have demand for machining centers. First of all, let's say that the three-axis machining center is the most widely used. The three axes include XYZ axis, which is also called the three-axis linkage machining center. Three-axis machining center can carry out simple plane machining, and only one side can be machined at a time. Three-axis machining center can process aluminum, wood, EPC and other materials well.
Legal basis:
Road Traffic Safety Law of the People's Republic of China
Article 93 When a vehicle is detained by law enforcement, it is absolutely not allowed to collect the so-called parking fee. It is a normal law enforcement behavior for the traffic police to temporarily detain the vehicle. The expenses incurred by detaining the vehicle belong to the normal law enforcement expenditure of the traffic police team, and the owner has no obligation to pay for the entrusted behavior of the traffic police. After the traffic police handle the violation, they should give the car to the owner intact. The law does not stipulate that car owners must pay, so there is no basis for car owners to pay parking fees.