One: The reason why the feeder vibrates greatly when working:
1, the raw material is too curved.
2. Raw materials are not chamfered
3. The center position is misplaced
Countermeasures:
1, try to buy straight materials.
2. Tail chamfering
3. Recalibrate the center.
Two: can't start.
Cause: The power supply is not connected. Countermeasure: Check whether the power supply is connected properly.
Three: insufficient pressure
Reason: 1, insufficient hydraulic oil.
2. Is the motor working normally?
3. The filter screen is blocked. 4. The sealing ring is damaged.
Countermeasures: 1, replenish hydraulic oil
2, check the line connection
3. Replace the filter element
4. Replace the sealing ring
Four: when changing materials, the bar can't enter the feeder.
Reason: The setting of retraction time is too short, and the push rod cannot be completely retracted to the tail of the feed tube.
Countermeasures: press and hold the "Set" key, then press "Add" to increase the return time, and press the "Set" key twice to return to the working state.
Five: The feeder will not give an alarm (return)/give an alarm in advance after feeding.
Reason: 1, insufficient pressure 2, incorrect feed pipe position 3, whether the motor works normally.
Countermeasures: 1, check the oil quantity 2, move the material pipe 3 slightly, and check the line for danger-it may cause serious injury.
Please be extra careful. 1. Wrong adjustment may lead to feeder failure or machine tool damage. 4. When the equipment is running, don't touch the mechanical power device with any part of your body. 3. Only when the power supply is cut off and there is no pressure can mechanical repair and maintenance be carried out.