Legal analysis
If the flow rate is far below the minimum flow rate to ensure accuracy, there will be no output (such as vortex flowmeter) or the output signal will be cut off as a small signal (such as differential pressure flowmeter), which is unfavorable and unfair to suppliers. In order to prevent the loss of benefits, for a specific set of thermal energy metering equipment, the supply and demand sides often agree that a certain flow value is the "agreed lower limit flow" according to the flow measurement range and the achievable range, and agree that if the actual flow is less than the agreed value, it will be charged according to the lower limit flow. The metrological administrative department of the people's government at or above the county level may set up metrological verification institutions according to needs, or authorize metrological verification institutions of other units to perform compulsory verification and other verification and testing tasks. Personnel who perform the verification and testing tasks specified in the preceding paragraph must pass the examination. This function is usually realized in the flow display instrument. The metrological administrative department of the local people's government at or above the county level shall, according to the needs of the local area, establish public standard instruments of measurement, which shall be used after passing the examination presided over by the metrological administrative department of the people's government at a higher level. Enterprises and institutions may, as required, establish standards of measurement for their own use, and the highest standards of measurement shall be used after passing the examination presided over by the metrological administrative department of the relevant people's government. Metrological verification shall be carried out on site in accordance with the principle of economy and rationality. Metrological verification must be carried out in accordance with the national metrological verification system table. The national metrological verification system table shall be formulated by the metrological administrative department of the State Council.
legal ground
Article 49 of People's Republic of China (PRC) Company Law A limited liability company may have a manager, and the appointment or dismissal shall be decided by the board of directors. The manager is responsible to the board of directors and exercises the following functions and powers: (1) to preside over the production, operation and management of the company and organize the implementation of the resolutions of the board of directors; (2) Organizing the implementation of the company's annual business plan and investment plan; (3) To formulate plans for the establishment of the company's internal management organization; (4) To formulate the basic management system of the company; (5) To formulate specific rules of the company; (six) to propose the appointment or dismissal of the company's deputy manager and financial officer; (7) To decide on the appointment or dismissal of management personnel other than those who should be decided by the board of directors; (8) Other powers granted by the board of directors. Where there are other provisions in the articles of association on the functions and powers of the manager, such provisions shall prevail. The manager attended the board meeting.